Paxar 9854 User Manual
Page 22
05/08 Rev. AB
OPERATOR’S HANDBOOK
Getting Started
9844/9854
1-14
Setting the Interface
By factory default, the printer is set for data transfer using the Centronics
interface. Print data can be transferred using the RS232, USB or Ethernet
interface (9854 only).
«
Select the interface with the following parameter:
Set INTERF. PARAM. > EASYPLUGINTERPR to Interface
P
Refer to the “Info-Printouts and Parameters” section on your CD-ROM for
more information about setting parameters.
P
Refer to the “Advanced Applications” section of your CD-ROM for more
information about using 9854 Ethernet.
Using the 9854 Printer with Internal Liner Takeup
Disable
«
Set SYSTEM PARAMETER > Periph. Device to None
¯
If you do not insert printing material before enabling the liner takeup, an
error message appears.
P
For more information on loading material, see “Loading Material.”
Enable
1. Set SYSTEM PARAMETER > Periph. Device to Intern Rewinder
When enabled, the rotational direction of the takeup is set.
2. Press Cut/Feed to change the rotation direction.
3. Press Enter to confirm your setting.
The printer restarts. The main menu now contains the additional menu
REWINDER PARA, which holds the parameter Rewind direction. This can be used
to change the rotational direction.
During initialization, the printer attempts to stretch the label material.
Possible Errors
Shortly after enabling the internal liner takeup, you may see
Rewinder direct.
Facing outside
Facing outside is the default setting.
Status 5004
Rewinder mat. tear