Peavey 1000 - Manual (Page 7)

Blending and crossfading between all channels is accessible by assigning channels 2, 3, or 4 for left- and
right-hand positioning of the crossfader slider. For example:
Left-hand ASSIGN switch set to channel will access channel 3 when the crossfade slider is in the
left-hand position.
Right-hand ASSIGN switch set to channel will access channel 2 when the crossfade slider is in
the right-hand position.
NOTE: It is useful to remember that when the crossfade slider is set to its center (number 5) position, both
channels assigned to the left- and right-hand crossfade positions will be at equal levels. You may then
simply use the channel level controls to crossfade between the two assigned channels and ignore the
crossfade, leaving it set in the center position. This is a more “European” technique of crossfading and is
preferred by some
External 39 V AC 1 amp power supply should be plugged in at this point. Turn unit power switch off (number
23). Plug the small jack at the end of the power supply lead into the 39 V AC socket on the rear of the unit.
Plug the power supply provided with your PM 1000 into a main AC wall power receptacle. Turn unit power
switch on (number 23) to activate unit.
CAUTION: Use only the power supply that is provided with this product. If the original power supply
must be replaced, consult your dealer or the factory for assistance in obtaining the correct replace-
ment. Failure to use the correct power supply could result in fire or shock hazard, extensive circuit
damage, decreased performance, or non-operation.
Monitor output left and right jacks are provided for monitoring main Left and Right signals. The output at this
point should be patched to the stereo power amplifiers driving the monitor speaker system.
NOTE: It is often useful to use the monitor outputs to drive an independent sound system for another audio
zone such as a second dance floor or background music elsewhere within the venue.
Main output left and right jacks are provided for the main (program) output. The output at this point should
be patched to the stereo power amplifiers driving the main speaker system.
7