Panasonic DMC-FX700 - Manual (Page 47)

- 47 -
Basic
Note
• The indicated zoom magnification is an approximation.
• “EZ” is an abbreviation of “Extended Optical Zoom”.
• The Optical Zoom is set to Wide (1 k) when the camera is turned on.
• If you use the Zoom function after focusing on the subject, focus on the subject again.
• The lens barrel extends or retracts according to the zoom position. Take care not to interrupt
the motion of the lens barrel while the zoom lever is rotated.
• When using the Digital Zoom, [STABILIZER] may not be effective.
• When using the Digital Zoom, we recommend using a tripod and the self-timer (P63) for taking
pictures.
• [I.RESOLUTION] is fixed to [i.ZOOM] in Intelligent Auto Mode (when [MOTION DEBLUR] is set
to [OFF]), or Scene Mode
¢
.
¢ [i.ZOOM] cannot be used when in [HANDHELD NIGHT SHOT], [HIGH SENS.],
[FLASH BURST] or [PIN HOLE] in Scene Mode.
• The Extended Optical Zoom cannot be used in the following cases.
– In [MOTION DEBLUR] in Intelligent Auto Mode
– In Macro Zoom Mode
– In [TRANSFORM], [HIGH SENS.], [FLASH BURST], [PIN HOLE] or [PHOTO FRAME] in
Scene Mode
– When recording motion pictures
• [DIGITAL ZOOM] cannot be used in the following cases.
– In [TRANSFORM], [HANDHELD NIGHT SHOT], [HIGH SENS.], [FLASH BURST],
[PIN HOLE], [FILM GRAIN] or [PHOTO FRAME] in Scene Mode
– In Intelligent Auto Mode
Zooming with touch operation
Touch [ ].
• Zoom lever is displayed on the LCD monitor.
Touch the Tele or Wide side of the zoom
lever on the screen.
• Zoom position will automatically move to Tele when
[
] is touched, and to Wide when [ ] is touched.
Zooming will stop where it is if you touch again while
zooming.
• Zoom lever will disappear when no operation is
performed for approximately 5 seconds.