Philips xDV434/19 - Manual (Page 10)

3139 246 16611
English
10
Connections
AUDIO IN
V (Pr/Cr)
U (Pb/Cb)
Y
S-VIDEO IN
VIDEO IN
COMPONENT VIDEO IN
AUDIO IN V (Pr/Cr) U (Pb/Cb) Y
S-VIDEO IN
VIDEO IN
COMPONENT VIDEO IN
2 1
IMPORTANT!
– The progressive scan video
quality is only possible when using
YPbPr and a progressive scan TV is
required.
Using Component Video jacks
(YPbPr)
1
Use the component video cables (red /
blue / green) to connect the DVD system’s
Y Pb Pr jacks to the corresponding
Component video input jacks (or labeled
as YPbPr) on the TV
(cable not supplied).
2
To hear the sound of this DVD Player
through your TV, use the audio cables
(white/red) to connect AUDIO OUT (L/
R) jacks of the DVD Player to the
corresponding AUDIO IN jacks on the TV
(cable not supplied).
3
Proceed to page 16 for detailed
Progressive Scan set up.
IMPORTANT!
– If your TV only has a single
Antenna In jack (or labeled as 75
ohm or RF In,) you will need an RF
modulator in order to view the DVD
playback on the TV. See your
electronics retailer odetails on RF
modulator availability and
operations.
Using an accessory RF modulator
1
Use the composite video cable (yellow) to
connect the DVD Player’s CVBS jack to
the video input jack on the RF modulator.
2
Use the RF coaxial cable (not supplied) to
connect the RF modulator to your TV’s
RF jack.
AUDIO IN
R L VIDEO
IN
TO TV INT IN
CH3 CH4
2
1
RF coaxial cable to TV
Back of RF Modulator
(example only)
Antenna or
Cable TV signal
01-39 xDV434_Eng_191 13/04/05, 1:48 PM 10