Precor Programmable Ergometer 9.5sp - Manual (Page 8)

page 8
Handrail/display assembly
Photo 1
Install handrail/
display assembly.
5. Locate the ribbon cable connector that protrudes from the handrail/display
assembly.
6. Align the tab on the side of the ribbon cable connector with its correspond-
ing receptacle on the printed circuit board located near the motor. (See
Photo 2.) Make sure that all pins are aligned and fully engaged. The
connector is designed to engage in one direction only. Do not force the
connector into the receptacle.
Install ribbon
cable connector. Photo 2
Ribbon cable connector
4. Position the handrail assembly so both the right and left handrail columns
align over the mounts. (See Photo 1.) Replace the washers and locknuts.
Using the 1/2" box end wrench, begin to tighten each locknut. Alternate
between each one until all four locknuts are snug up against the handrail
columns.
Handrail/display assembly mount
Handrail/display assembly
Ribbon cable connector receptacle
Printed circuit board