Pride Mobility Maxima - Manual (Page 32)

32 www.pridemobility.com Maxima
I X . D I S A S S E M B LY A N D A S S E M B LY
NOTE: There is no need to disconnect the motor harness when disassembling the scooter. See figure 20.
8. Lift both batteries off the scooter. See figure 21.
9. Push the locking cam levers forward to the unlocked position and remove the ball detent pins. See figures 22 and 23.
10. Remove the frame handle ball detent pin. See figure 24.
11. Gently slide the two sections of the scooter apart. See figure 25.
12. Grab the handle grip on the tiller, pull upward on the tiller adjustment lever, and fully lower the tiller down to the
center of the scooter chassis.
WARNING! Failure to unplug both battery harnesses and the front-to-rear harness prior
to frame separation could result in permanent damage to the scooter.
Figure 20. Motor Harness Figure 21. Battery Removal
MOTOR
HARNESS
#
Figure 25. Frame Separation Figure 24. Frame Handle Ball Detent Pin
Figure 22. Locking Cam Levers (Unlocked Position) Figure 23. Frame Lock-up Ball Detent Pins