Panasonic EW3153 - Manual (Page 13)

11 English 1 English
When Using the Main Unit with Batteries
*Always use alkaline batteries. (4 AA-size Panasonic LR6 alkaline
batteries)
When replacing batteries, always use 4 fresh alkaline batteries of the
same type from the same manufacturer, and replace them
simultaneously.
1. Turn the main unit over and
remove the battery cover by
sliding it in the direction of
the arrow while pressing
lightly on the
mark.
2. Check the polarities of the
batteries and install them
correctly.
3. Replace the battery cover
and slide it closed.
Notes for using the main unit with batteries
Approximately 150 measurements can be taken. Depending on the
conditions, battery life may be dramatically shortened.
Use of the main unit with the dedicated AC adapter (EW31555)
(included) is recommended.
Replace batteries when:
The mark shown to the left appears during use.
No display appears even if the On/Off and Start button is
pressed.
•
•
CAUTION:
Always follow the cautions printed on the batteries.
Check the polarities of the batteries and install them correctly.
Remove exhausted batteries promptly.
If the product will not be used for long periods of time, remove the
batteries first.
Batteries should be used before their expiration date.
Use after the expiration date may result in injury or staining of the
surrounding area due to generation of heat, bursting, or leakage.
•
•
•
•
•
•
Parts Identification
(continued)
Wireless display
View from Bottom
1 Blood pressure indicator 6 Memory/Recall button
2 Display 7 User selection button
3 Set button 8 Battery cover for wireless display
4 Adjust button (Display off) 9 IR receiver
5 AM/PM comparison button
* Specifications of the product or parts may be changed without prior notice.
When Using the Main Unit with the AC Adapter
Be sure to use only the exclusive AC adapter (included).
Do not use the power cord with any product other than this AC
adaptor (EW31555).
Use of other AC adapters could cause damage to the unit or physical
harm to the user.
AC 10 V 1. Connect the power cord to the
AC adaptor.
2. Insert the AC adapter plug into
the connector on either side of
the main unit.
3. Plug the power cord fully into
the AC outlet.
11-12 2008/01/15 14:54:25