Inserting the batteries into the wireless display, Setting the time and date – Panasonic EW3153 User Manual

Page 14

Advertising
background image

13

English

14

English

Inserting the Batteries into the Wireless Display

*Always use alkaline batteries. (2 AA-size LR6 alkaline batteries)

When replacing batteries, always use  fresh alkaline batteries of the

same type from the same manufacturer, and replace them

simultaneously.

1. Turn the wireless display over and remove

the battery cover by sliding it in the
direction of the arrow while pressing
lightly on the

mark.

2. Check the polarities of the batteries and

install them correctly.

3. Replace the battery cover and slide it

closed.

Replace batteries when:

The mark shown at left appears during use.

In this case, press the On/Off and the Start button on the

main unit to interrupt the measurement.

If both batteries for the main unit and the wireless display must be
replaced at the same time,

(main unit) and

(wireless display)

are alternately displayed.

Setting the time and date

* Please be sure to set the date and time before taking the first

measurement after purchasing the blood pressure monitor, or after
replacing the batteries.

(If you attempt to take measurements without first setting the time and

date then “–” will be displayed.)

1. Press the Set button “1” on the wireless

display for at least 3 seconds.

2. Adjust the month.

Press the Adjust button “” to adjust the

number of the month.

3. Adjust the date.

(1) Press the Set button “1” and the number for

the date will flash.

() Press the Adjust button “” to adjust the

number of the date.

4. Adjust the hour.

(1) Press the Set button “1” and the time will

flash on and off.

() Press the Adjust button “” to adjust the

number of the hour.

5. Adjust the minutes.

(1) Press the Set button “1” and the number for

minutes will flash.

() Press the Adjust button “” to adjust the

number of minutes.

6. Finally, synchronizing with a time signal,

press the Set button “1” to complete the
procedure.

The date and time are alternately displayed in

approximately  seconds.

7. Press the Adjust button “2” to turn off the unit.

During leap years, 3/1 will be displayed when it is February 9th. Please

manually reset the date to /9.

13-14

2008/01/15 14:54:25

Advertising
This manual is related to the following products: