Figure 32 – ParaBody 425103 User Manual
Page 29
Advertising
29
0
1
2
3
4
5
6
1/2
1/2
1/2
1/2
1/2
1/2
FIGURE 32
STEP 32
• To assemble the D-RING CABLE (102) follow the cable routing as shown and use the following steps:
• Screw one of the threaded ends of the D-RING CABLE (102) approximately 1” into the end of the SELECTOR SHAFT (73) of
the HEAD PLATE (72) as shown in FIGURE 32.
• Route the CABLE (102) up and over the two PULLEYS in the TOP BOOM (17) above the WEIGHT STACK. (Remove pulleys
for ease of installation.)
• Screw the other threaded end of the D-RING CABLE (102) approximately 1” into the end of the shaft on the D-RING (7) as
shown in FIGURE 32.
• SECURELY tighten two pulley connections from the previous step.
17
72
73
7
102
Advertising