Philips Remote Starter - Manual (Page 27)

EN-25
EN
GLISH
Press 1. GUIDE on the remote control.
Press 2. MENU on the remote control.
The Programme guide menu appears.
Programme guide What's on
12:30 South Today
13:00 In aller Freund
11:50 Working Lunch
11:55 Melrose Place
Preferred EPG ch...
Acquire EPG data
What's on
Search by genre
Scheduled remind...
Press 3.
Î
or ï to select a menu option.
Press 4.
Æ
to enter.
Press 5.
Î
or ï to make a selection.
Press 6. OK or the green key to activate the
selection.
Press
7. GUIDE to exit the EPG.
Note D
Only channels marked as preferred EPG
channels appear in the Programme guide
menu.
5�8 Use timers and Child lock
This section describes how to switch the TV on
or off at a specified time and to use Child lock.
5�8�1 Automatically switch the TV to
standby (Sleeptimer)
Sleeptimer switches the TV to standby after a
defined period of time.
Press 1. MENU on the remote control
and select TV menu > Features >
Sleeptimer.
Press
2.
Æ
to enter the Sleeptimer bar.
Press 3.
Î
or ï to set the sleep time. This
can be up to 180 minutes in steps of
five minutes. If set to zero minutes, the
Sleeptimer is switched off.
Press
4. OK to activate the Sleeptimer.
Note D
You can always switch off your TV earlier or
reset Sleeptimer during the countdown.
5�8�2 Automatically switch the TV on
(On timer)
On timer switches the TV to a specified
channel at a specified time, from standby.
Press 1. MENU on the remote control
and select TV menu > Features > On
timer.
Press
2.
Æ
to enter the On timer menu.
Use 3.
Î
or п, Н or Æ to select and enter
the menu items to set a channel, day of the
week, frequency and starting time.
Press
4. OK to confirm.
Press 5. MENU to exit.
Tip E
To switch off On timer, select Off in the
On timer menu.
5�8�3 Lock TV channels or connected
devices (Child lock)
Lock TV channels or connected devices with
a four digit code to prevent children from
watching unauthorised content.
To set or change the Child lock code
Press 1. MENU on the remote control and
select TV menu > Features > Set code
or Change code.
Press
2.
Æ
to enter the code setup.
Enter your code with the number keys. 3.
The Features menu reappears with a
message confirming that your code is
created or changed.
Tip E
If you forget your code, enter ‘8888’ to
override any existing codes.