Panasonic DMR E50 - Manual (Page 45)

45
RQT6920
Ad
v
a
nc
e
d
ope
ra
tion
Changing the remote control code
Panasonic DVD players and recorders use the same remote control
system so they may respond unintentionally to a command from this
remote control. Change the code on this unit and its remote control
(the two must match) if you place equipment close together.
≥ Use “1”, the factory set code, under normal circumstances.
1
While stopped
Press [SETUP] to show the menus.
2
Press [ 3 , 4 ] to select “Set Up” and
press [ 1 ].
3
Press [ 3 , 4 ] to select “Remote Con-
trol Code” and press [ENTER].
4
Press [ 3 , 4 ] to select the code (1, 2,
or 3) and press [ENTER].
The remote control code on the unit has been set.
5
While pressing [ENTER] on the
remote control, press the numbered
button ([1], [2] or [3]) corresponding
to the code you selected in step 4.
The remote control code on the remote control has been set.
6
Press [SETUP]
The following display appears when you use a remote control with a
different code.
If you are trying to use this unit’s remote control, change its code to
match the unit’s (
➜ step 5).
OPEN/CLOSE
SETUP
ERASE F Rec POSITION MEMORY MARKER
AUDIO INPUT SELECT
CM SKIP
STATUS FRAME
DISPLAY
STOP
PAUSE PLAY/ a 1.3
DVD
VCR Plus+ TV/VIDEO REC MODE REC
CH
VOLUME
TV
TV DVD
1 2 3
7 8 9
0 100
4 5 6
SLOW/SEARCH SKIP
DIRECT NAVIGATOR
TOP
MENU
MENU
RETURN FUNCTIONS
PROG/CHECK TIME SLIP ADD/DLT
ENTER
PLAY LIST
CANCEL
POWER
Н Н
SETUP
3 , 4 , 2 , 1
ENTER
Numbered
buttons
TAB SELECT
Antenna System
Auto Channel Setting
Channel Caption
Preset Channel Caption
Manual Channel Caption
VCR Plus i CH Setting
CATV
Channel
SETUP
RETURN
Set Up
Disc
Video
Audio
Display
TV Screen
The unit’s remote control code