Polaroid P100i - Manual (Page 12)

4
P100i
User’s Manual
General Information
Getting Started
Operation
Printing a Card
Cleaning
Troubleshooting
Specifications
Appendix A
Appendix B
Appendix C
Polaroid
1•3 Printer Installation
The following will guide you through the installation of your P100i
printer.
CAUTION: Limit AC power supplied to the
P100i Printer to 110 - 230 V AC, 60 - 50 Hz for
an associated 680 mA - 310 mA. Limit excess
current draw to 16 amps or less, using an
associated circuit breaker or other such device.
Never operate the printer in a location where
operator, computer, or printer can get wet.
Personal injury could result. The printer must
be connected to an earthed electrical power
supply and properly protected against electrical
surges and grounding faults.
CAUTION : Intermittent or unpredictable operation may
occur from unsecured connectors. If damaged, the
power cable must be replaced by an exact equivalent.
Use only Parallel Cable under 3 Meters in length.
1. Place the printer in a location that allows
easy access to all sides. The printer should
never be operated while resting on its side or
upside down.
2. Place the power switch in the OFF (0)
position.
3. Insert the power cable into the printer power
socket and attach to grounded electrical
socket of the proper voltage and type.
Continued on following page