Panasonic TH-LB30NT - Manual (Page 62)

62
Using WebBrowser
(cont.)
This page indicates the projector status.
To access this page from other pages, click [Status] at the left of the window.
Monitor information window
The monitor information is refreshed at fixed intervals, but the current exact information can be checked by clicking [View] →
[Refresh].
Projector status
On this window, click the [Projector status] tab.
Network status
On this window, click the [Network status] tab.
If [SELF TEST Error (Detail)] appears on the monitored information window,
click it to view the error details.
n
If [FAILED] appears
Item Description
MAIN CPU BUS There is a problem with a microcontroller circuit. Contact your dealer.
FAN There is a problem with the fan or fan drive circuit. Contact your dealer.
INPUT AIR TEMPERATURE Input air temperature is high. The projector is likely being used in a high temperature
environment such as near heating equipment.
OUTPUT AIR TEMPERATURE Temperature surrounding the lamp is high. The exhaust vent is likely blocked.
LAMP REMAIN TIME The lamp has been used for longer than its rated useful life, and it is time to replace it.
LAMP STATUS The lamp could not be lit.
Allow the bulb of the light source to cool, and then turn on the projector.
INPUT AIR TEMP.SENSOR There is a problem with the air intake temperature sensor. Contact your dealer.
OUTPUT AIR TEMP.SENSOR There is a problem with the exhaust temperature sensor. Contact your dealer.
BATTERY The battery must be replaced. Contact your dealer.
ACF UNIT Either the ACF unit is not set properly or it does not work. For further detail, see the
instruction manual for the projector.
FILTER REMAIN The remaining filter gets low. For further detail, see the instruction manual for the
projector.