Connect power, Set clock – Philips AJ7030D User Manual
Page 12
Note
You can only use AC power as power supply. The pre-installed
•
lithium CR2032 battery can only back up time and alarm.
When power is disconnected, the display backlight is off.
•
For fi rst-time use:
Remove the protective tab to activate the battery.
To replace the battery:
B
Connect power
C
Caution
Risk of product damage! Ensure that the power voltage corresponds
•
to the voltage printed on the back or underside of the clock radio.
Risk of electric shock! When you unplug the AC adapter, always pull
•
the plug from the socket. Never pull the cord.
Set clock
1
In standby mode, press and hold SET for two seconds
to activate clock setting mode.
»
[12H] or [ 24H] is displayed.
2
Press
TUNING +/- or / repeatedly to select 12/24
hour format.
3
Press
SET again to confi rm.
The hour digits begin to blink.
»
4
Repeat Steps 2 to 3 to set the hour and minute.