Polycom SpectraLink 1725-36034-001 - Manual (Page 48)

SpectraLink 8002 Wireless Telephones Configuration and Administration (SIP)
48 PN: 1725-36034-001_B.doc
Parameter Value Description Notes
*default 3600
seconds
messages. minimum setting than that
requested, the server
response takes precedence.
See example file
PROXYn_KEEPALIVE_S
ECS 0 or 10 to 3600
seconds
*default = 0
Specifies that the
handset should send
keepalives to the
PROXYn server. n = 1, 2, 3
The keepalive interval
defaults to ZERO which
disables the feature.
When specified, the interval
can be set to zero or to 10 to
3600 seconds.
If a keepalive fails to get a
response within the SIP 32
second timeout, then
keepalives are terminated
until the next successful
registration to the proxy.
See example file
PROXYn_HOLD_IP0 *enable
disable
*default (in example
file)
Controls setting of the
media stream IP
destination address to 0
(zero) when a call is put
on hold. See config file
example for more
information. n = 1, 2, 3
Use for compatibility with
older SIP servers that may
not recognize newer stream
attribute parameters for
HOLD status.
PROXYn
_MAIL_SUBSCR [email protected].
xxx
or
Contact to whom the
handset should
subscribe for mail
notification. See config
file example for more
information. n = 1, 2, 3
name = mail server contact
name.
xxx.xxx.xxx.xxx = IP address.
sip:name@domain Domain where the mail
resides
1 .
PROXYn_MAIL_ACCES
S [email protected].
xxx
or Contact to whom the
handset should invite to
access the mail center.
This is the main
voicemail dial number. n = 1, 2, 3
name = mail server contact
name.
xxx.xxx.xxx.xxx = IP address
1 For mail notifications, in general you will need to define only one contact parameter for each proxy. If the proxy server
automatically creates and renews subscriptions when the handset registers, then only the PROXYn _MAIL_NOTIFY contact need be
specified. If the handset must subscribe to a particular contact to get mail notification, then only the PROXYn_MAIL_SUBSCR
contact needs to be specified.