Philips HTS3540/51 - Manual (Page 14)

12
• [Disc Lock] : Restricts play to disc.
Password (PIN code) is required to
unlock the disc before play.
• [Display Dim] : Changes the brightness
of the display panel.
• [OSD Language] : Selects the on-
screen display menu language.
• [Screen Saver] : Enables or disables
screen saver mode. If enabled, the
screen enters idle mode after 10
minutes of inactivity (for example, in
pause or stop mode).
• [Sleep Timer] : Sets a sleep timer to
switch the home theater to standby
after a speciÀ c time.
• [Auto Standby] : Enables or disables
auto standby. If enabled, the home
theater switches to standby after 30
minutes of inactivity (for example, in
pause or stop mode).
• [DivX® VOD Code] : Displays the
DivX VOD registration code for the
home theater.
4
Press OK to conÀ rm your choice.
Note
Before you purchase DivX videos and play •
them on the home theater, register the home
theater on www.divx.com using the DivX
VOD code.
Change audio settings
1
Press SETUP .
2
Select [Audio Setup] , then press OK .
3
Select and adjust the following settings:
• [Speakers Volume] : Sets the volume
of each speaker to obtain the ideal
audio balance.
• [Speakers Delay] : Sets the delay time
for center and rear speakers to obtain
an equal audio transmission from all
the speakers.
• [HDMI Audio] : Enables or disables
HDMI audio output for the TV.
• [Audio Sync] : Sets a delay for audio
output when you play a video disc.
6 Change settings
This section helps you to change the settings of
your home theater.
Caution
Most of the settings are already conÀ gured •
with the best value for the home theater.
Unless you have a speciÀ c reason to change a
setting, it is best to leave it at the default value.
Access the setup menu
1
Press SETUP .
The following menu appears.
»
Symbol Description
[General Setup]
[Audio Setup]
[Video Setup]
[Preference Setup]
2
Select a setup menu, then press OK .
See the following sections for information
about how to change the settings of your
home theater.
3
Press BACK to return to the previous
menu, or press SETUP to exit.
Note
You cannot change a setting that is grayed out. •
Change general settings
1
Press SETUP .
2
Select [General Setup] , then press OK .
3
Select and adjust the following settings:
EN