Philips CQ-DFX972N - Manual (Page 35)

CD.C-IN
ACC
BATTERY 15A
35
CQ-DFX972N
32
E
N
G
L
I
S
H
C3 : External Remote Control Lead (Brown
w/black stripe)
When using a non-Panasonic external remote
control, refer to the manufacture for their
product before connecting.
C4 : External Amplifier Control Power Lead
(Blue w/white stripe)
To an external amplifier.
C2 : Dual CD Changer Control Lead (Brown
w/white stripe)
A5 : Motor Antenna Relay Control Lead (Blue)
To Motor Antenna (Max. 500 mA).
This lead is not intended for use with a switch
actuated power antenna.
Note: The power antenna extends automatically
when the power of this unit is turned on.
C1 : External Mute Lead (Orange)
To the Navi Mute lead of the Panasonic car
navigation system or car telephone mute lead.
B8 : Rear Left –
B7 : Rear Left +
B6 : Front Left –
B5 : Front Left +
B4 : Front Right –
B3 : Front Right +
B2 : Rear Right –
B1 : Rear Right +
(Orange)
ISO Connector A (Black)
ISO Connector B (Brown)
(Brown w/white stripe)
A8 (Black)
A7 (Red)
A4 (Yellow)
Fuse (15 A)
Resistor (1 k Ω)
A5 (Blue)
B8 (Green w/black stripe)
B7 (Green) B6 (White w/black stripe)
B5 (White )
B4 (Gray w/black stripe)
B3 (Gray) B2 (Violet w/black stripe)
B1 (Violet )
(Brown w/black stripe)
(Blue w/white stripe)
A7 : Power Lead (ACC or IGN) (Red)
To ACC power, +12 V DC.
A8 : Ground Lead (Black)
To a clean, bare metallic part of the car chassis.
A4 : Battery Lead (Yellow)
To the car battery, continuous +12 V DC.
Speakers
(L) (White)
(R) (Red)
CD Changer Input Cord
(Not used)
Cautions:
¡Check the connectors provided on your car (see precaution below) before
connecting the system.
¡This unit is designed for use in a car having a 12-volt negative ground battery
system.
¡To prevent damage to the unit, be sure to follow the connection diagram.
¡Strip about 5 mm of the lead ends for connection (only non-ISO connector
cords).
¡Do not insert the power connector into the unit until the wiring is completed.
¡Be sure to insulate any exposed wires to prevent short circuiting with the car
chassis. Bundle all cables, and prevent cable terminals from touching any
metal parts.