Replacing the speaker module – PACKARD BELL LJ61 User Manual
Page 124
Advertising
114
Chapter 3
Replacing the Speaker Module
1. Place the left Speaker Module in the chassis as
shown, ensuring that the locating pins are seated
correctly.
2. Lift the mylar sheet away from the Upper Cover and
run the Speaker cable along the Upper Cover using
all available cable clips.
3. Continue running the cable along the Upper Cover
using all available cable clips.
4. Place the right Speaker Module in the chassis as
shown, ensuring that the locating pins are seated
correctly.
5. Replace the four securing screws.
NOTE: Ensure that the Speaker cable runs as shown in the image below to avoid trapping when the Upper
Cover is replaced.
Advertising