Replacing the hard disk drive modules – PACKARD BELL LJ61 User Manual
Page 137
Advertising
Chapter 3
127
Replacing the Hard Disk Drive Modules
1. Place the HDD in the HDD carrier.
2. Replace the four screws (two each side) to secure
the carrier.
3. Insert the Secondary HDD, right side first, and
lower it into place.
4. Slide the Secondary HDD to the right to connect
the interface.
5. Insert the Primary HDD, right side first, and lower it into place. Slide the Primary HDD to the right to connect
the interface.
Advertising