PACKARD BELL LJ61 - Manual (Page 84)

74 Chapter 3
Removing the TouchPad Bracket
1. See “Removing the Upper Cover” on page 70.
2. Release the FFC locking latch and disconnect the TouchPad FFC from the cover.
3. Remove the single screw securing the TouchPad Bracket to the Upper Cover.
4. Hold down the left side of the bracket as shown. Lift and pivot the right edge in the direction of the arrow to
release the locking latches on the front edge.
5. Remove the bracket from the Upper Cover.
Step Size Quantity Screw Type
TouchPad Bracket M2*3 1