Audio settings – Philips MCD107/98 User Manual
Page 21
22
Select sampling rate
You can select the Linear Pulse Code
Modulation (LPCM) output sampling rate. The
higher the sampling rate, the better the sound
quality.
1
Press SYSTEM MENU.
2
Select [AUDIO SETUP] (audio setup) >
[DOWN SAMPLE] (down sample), then
press
.
3
Select an option, then press OK.
[
48K]: For discs recorded at sampling
rate of 48kHz.
[
96K]: For discs recorded at sampling
rate of 96 kHz.
[
192K]: For discs recorded at
sampling rate of 192 kHz.
4
Press SYSTEM MENU to exit.
Enable night mode
Night mode makes loud sound level softer so
that you can watch the DVD movies at a low
volume, without disturbing others.
1
Press SYSTEM MENU.
2
Select [AUDIO SETUP] (audio setup)
> [NIGHT MODE] (night mode), then
press
.
3
Select an option , then press OK.
[ON] (on): Enjoy quiet viewing at
night.
[OFF] (off ): Enjoy surround sound
with its full dynamic range.
4
Press SYSTEM MENU to exit.
4
Press
to adjust value, then press OK.
5
Press SYSTEM MENU to exit.
Audio settings
Select audio downmix
Select a suitable audio downmix when you
are playing a DVD recorded in Dolby Digital
format.
1
Press SYSTEM MENU.
2
Select [AUDIO SETUP] (audio setup) >
[DOWNMIX] (downmix), then press
.
3
Select an option, then press OK.
[LT/RT]: Select this if the unit is
connected to a Dolby Pro Logic
decoder.
[STEREO] (stereo): Select this when
output delivers sound from only the
two front speakers.
4
Press SYSTEM MENU to exit.
Select reverb mode
3D processing provides a virtual surround
sound experience using just two speakers.
1
Press SYSTEM MENU.
2
Select [AUDIO SETUP] (audio setup) >
[3D PROCESSING] (3d processing), then
press
.
3
Select an option, then press OK.
[OFF] (off ),
[CONCERT] (concert)
[CHURCH] (church)
[PASSIVE] (passive)
[WIDE] (wide)
[
LIVE] (live)
4
Press SYSTEM MENU to exit.
EN