Precor EFX 5.25 - Manual (Page 52)

Owner’s Manual: Advanced Programming and Troubleshooting 36
Advanced Programming and Troubleshooting
Certain features remain hidden and can only be accessed
using special keypresses. Read this section if you want to:
• Select the units of measure
• View the odometer
• Display the number of hours you have used your EFX
• View the software versions and part numbers
• Check the error log
In general, you would only access this information if
directed to do so by Precor Customer Support.
Advanced Programming Tips
• Always start at the Precor banner.
• The advanced programming and troubleshooting mode
is accessed by pressing and holding the ENTER key at
the Precor banner, then entering the appropriate key
combination. Any remaining key presses must occur
quickly and without pause.
• The QUICKSTART key is disabled while in advanced
programming mode.
• Use the arrow keys to change blinking prompts.
• Press ENTER to make selections and RESET to return
to the Precor banner.
Selecting a U.S. Standard or Metric
Display
The EFX can display measurements in either metric or U.S.
standard. The default factory setting is set to display U.S.
standard. To change this setting, perform the following
steps:
1. At the Precor banner, press and hold ENTER while
pressing the following keys in sequence without pause:
RESET, CROSSRAMP
▼, RESISTANCE ▲
Use the arrow keys to select a unit of measure (either
METRIC or U.S.).
2. When you are ready, press ENTER to accept the
displayed setting. The display indicates the setting is
saved. Press RESET to return to the Precor banner.
Note: Changing the display to metric measurements
affects the default settings. Distances and the odometer
values are converted to and appear in kilometers (KM).
Speed appears in kilometers per hour.
Viewing Other Settings
The EFX stores the total number of strides and the total
number of hours the unit has been in use. You can view this
information by performing the following steps: