Philips CD685 - Manual (Page 34)

34 EN
Manual registration
If auto registration fails, register your handset
manually to the base station.
1
Select [Menu] > > [Register], then
press [OK] to confirm.
2
Press and hold on the base station for
5 seconds until you hear a confirmation
beep.
3
Enter the system PIN. Press [Clear] to
make corrections.
4
Press [OK] to confirm the PIN.
» Registration is completed in less than 2
minutes. The base automatically assigns
a handset number to the handset.
Note
• If the PIN is incorrect or no base is found
within a certain period, your handset displays
a notification message. Repeat the above
procedure if registration fails.
Note
• The preset PIN is 0000. No change can be
made on it.
Unregister the handsets
1
If two handsets share the same base
station, you can unregister a handset with
another handset.
2
Select [Menu] > > [Unregister], then
press [OK] to confirm.
3
Select the handset number to be
unregistered.
4
Press [OK] to confirm.
» The handset is unregistered.
Tip
• The handset number displays beside the handset
name in standby mode.
Call services
The call services are network and country
dependent. Contact your service provider for
more information.
Note
• For the call services to work properly, ensure
that the activation and/or deactivation codes are
correctly entered.
Call forward
You can divert your calls to another phone
number. You can select among 3 options:
• [Call forward]: divert all incoming calls to
another number.
• [Call fwd busy]: divert calls when the line
is busy.
• [Call fwd unans]: divert calls when no
one answers.
Activate/Deactivate call forward
1
Select [Menu] > > [Call Services] >
[Call forward]/[Call fwd busy]/[Call fwd
unans]
2
Select [Activate]/[Deactivate], then press
[OK] to confirm.
3
Enter the telephone number.
» The setting is saved .
Edit the activation/deactivation code
You can edit the prefix and suffix to the call
forward codes.
1
Select [Menu] > > [Call Services] >
[Call forward]/[Call fwd busy]/[Call fwd
unans], then press [OK] to confirm.
2
Select [Change code], then press [OK].
3
Then you can either
• Select [Activation] >
[Prefix]/[Suffix], then press [OK] to
confirm; or