Philips CD685 - Manual (Page 5)

5 EN
1 Important safety
instructions
Power requirements
• This product requires an electrical supply
of 100-240 volts AC. In case of power
failure, the communication can be lost.
• The voltage on the network is classified
as TNV-3 (Telecommunication Network
Voltages), as defined in the standard EN
60950.
Warning
• The Electrical network is classified as hazardous.
The only way to power down the charger is to
unplug the power supply from the electrical
outlet. Ensure that the electrical outlet is always
easily accessible.
To avoid damage or malfunction
Caution
• Use only the power supply listed in the user
instructions.
• Use only the batteries listed in the user
instructions.
• Do not allow the charging contacts or the battery
to come into contact with metal objects.
• Do not open the handset, base station or
charger as you could be exposed to high
voltages.
• Do not allow the product to come into contact
with liquids.
• Risk of explosion if battery is replaced by an
incorrect type.
• Dispose of used batteries according to the
instructions.
• Always use the cables provided with the
product.
• For pluggable equipment, the socket-outlet shall
be installed near the equipment and shall be
easily accessible.
• Handsfree activation could suddenly increase
the volume in the earpiece to a very high level:
make sure the handset is not too close to your
ear.
• This equipment is not designed to make
emergency calls when the power fails. An
alternative has to be made available to allow
emergency calls.
• Do not expose the phone to excessive heat
caused by heating equipment or direct sunlight.
• Do not drop your phone or allow objects to fall
on your phone.
• Do not use any cleaning agents containing
alcohol, ammonia, benzene, or abrasives as
these may harm the set.
• Do not use the product in places where there
are explosive hazards.
• Do not let small metal objects come into
contact with the product. This can deteriorate
audio quality and damage the product.
• Active mobile phones in the vicinity may cause
interference.
• Metallic objects may be retained if placed near
or on the handset receiver.
When using the phone as a baby monitor
Caution
• Children should be supervised to ensure that
they do not play with the appliance.
• Make sure the baby unit and the cord are always
out of reach of the baby (at least 1 metre/3 feet
away).
• Keep the parent unit at least 1.5 metres/5 feet
away from the baby unit to prevent acoustic
feedback.
• Never place the baby unit inside the baby’s bed
or playpen.
• Never cover the parent unit and the baby unit
with anything (e.g. a towel or blanket). Always
make sure the cooling vents of the baby unit
are free.
• Take every precaution to make sure that your
baby can sleep safely .
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
• If you place the parent unit next to a transmitter
or other DECT appliance (e.g. a DECT
telephone or wireless router for the internet),
the connection with the baby unit may be lost.
Move the baby monitor further away from the
other wireless appliances until the connection is
restored.
• This baby monitor is intended as an aid. It is not
a substitute for responsible and proper adult
supervision and should not be used as such.
English