Pioneer DVR-LX70 - Manual (Page 124)

Additional information 15
124
En
Remote control does
not work • If you connected this recorder to another Pioneer product using the
CONTROL IN jack, point the remote control at the other component
to use (page 14).
• Set the remote control to the same ID number as the recorder
(page 118). (When the batteries run down, the remote mode is
automatically reset to
Recorder1.)
• Use the remote within its operating range (page 6).
• Replace the batteries (page 6).
No sound or sound is
distorted • Make sure that the amplifier/receiver or TV is set to the correct
input and the volume turned up.
• There is no sound when the picture is paused, or during scanning
or slow motion play. Press
 PLAY to resume regular playback.
• DTS discs can only be played if this recorder is connected to a DTS
decoder or DTS compatible amplifier/receiver. If you have connected
a suitable decoder, also make sure that the
Initial Setup > Audio
Out > DTS Out setting is On.
• Some 96 kHz discs do not output audio through the digital jack. In
this case, switch the input of your amplifier/receiver to analog.
• Check the audio cable connections (page 14).
• If the sound is distorted, try cleaning the cable plugs.
Cannot switch a dual
mono/bilingual
programme • During real-time copying it is not possible to switch audio
channels. The main and sub channels are both output.
The picture is
distorted • Change the Input Line System setting (page 108). (You can also
change it by pressing the
 (Stop) button and INPUT SELECT on the
front panel simultaneously with the recorder stopped.)
The picture from the
external input is
distorted • If the video signal from the external component is copy-protected,
you cannot connect via this recorder. Connect the component
directly to your TV.
Screen is stretched
vertically or
horizontally • Make sure that the TV Screen Size setting (page 115) is correct for
the kind of TV you have (see also page 134).
• If you have a widescreen TV, check its aspect ratio settings.
• This recorder’s input switches into wide mode automatically
according to the input signal. When the unit connected is not
compatible with VIDEO ID-1 (widescreen signalling), set the
connected component to output 4:3 aspect ratio (standard) video.
Problem Remedy
DVRLX70_TF_EN.book 124 ページ ２００７年８月１日 水曜日 午後４時１４分