Philips XL3402 - Manual (Page 12)

10 Getting started
4 Getting started
4.1 Connect the base
Place the base station close enough to the
telephone and the mains power sockets so that
the cables will reach.
Connect the telephone line cord to the
phone socket on the bottom of base unit and
the wall phone sockets.
Note
To use this phone, you need an RJ11C (CA11A)
type modular telephone jack, which might look
like the one pictured here, installed in your home.
If you do not have a modular jack, call your local
phone company to find out how to get one
installed.
Connect output plug of power adapter to the
power socket on the bottom of base unit.
Connect the power adapter to the wall mains
supply.
Warning
The electrical network is classified as dangerous
according to criteria in the standard EN 60950.
The only way to power down this product is by
unplugging the power supply from the electrical
outlet. Ensure the electrical outlet is located
close to the apparatus and is always easily
accessible.
4.2 Connect the charger
If you have bought a multi-pack product, each
extra handset comes with a charger and a charger
adaptor.
Connect the output plug of the charger
adaptor to the bottom of the charger.
Connect the charger adaptor to the wall
mains supply.
4.3 Insert the batteries in the handset
Place the two rechargeable batteries
(included) into the battery compartment.
Warning
Verify the batteries polarity when inserting the
batteries. Incorrect polarity may damage the
product.
Slide the battery door firmly into place.
Warning
RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE. USE
RECOMMENDED TYPE SUPPLIED WITH THIS
PRODUCT. NEVER USE NON-RECHAR-
GEABLE BATTERIES.
4.4 Charge batteries
Warning
The base station must always be plugged into the
mains when charging or when in use. Place
handset on the base unit or the charger and let
1
2
!
1
2
1
!
2
!
!