Panasonic AW-HB605 - Manual (Page 6)

11 10
System Connections (Indoor Pan/tilt Head System)
O Turn off the power to all pieces of
equipment before making any
connections.
O For the control panel, use the AC
adapter model AW-PS301 (sold
separately), for the multi port hub and
multi control hub, the AC adapter model
AW-PS505 (sold separately), and for the
pan/tilt head AC adapter model, the AW-
PS300 (sold separately).
O Use an AW-PH300 series pan/tilt head
and a camera from the convertible
camera series.
Use camera cable AW-CA50 T15 (sold
separately) to make connections
between the pan/tilt head and camera.
O Connect the pan/tilt head (AW-PH300)
to its AC adapter (AW-PS300) using a
DC power cord (cable conforming to the
Electrical Equipment Handling Law and
with a nominal cross-sectional area of
1.25 mm
2 or more, to be obtained
locally). The maximum cable distance
between the pan/tilt head and its AC
adapter is 30 meters.
O Connect the multi control hub to its AC
adapter (AW-PS505).
O Connect the multi port hub to its AC
adapter (AW-PS505).
O Connect the control panel (AW-RP301,
AW-RP305, AW-RP501, AW-RP505) to
its AC adapter (AW-PS301). Use a cord
clamper to secure the DC cord of the
AC adapter and prevent the DC plug
from coming loose accidentally.
O Connect the pan/tilt head and the
convertible camera using the AW-CA50
T15 camera cable.
O Connect the electric zoom lens iris
control cable to the camera and the
remote (zoom and focus control) cable
to the pan/tilt head.
Cord clamper
Control panel AC adapter:
AW-PS301
DC cord
Remote (zoom/focus
control) cable
Iris control cable
To lens interface
connector
To iris connector
Controls and Their Functions
< Priority Switchbox Contacts
(Terminal Panel)
These are the output contacts of the
priority switchbox. They should be
connected to the TALLY terminals on
the control panel. These terminals are
not polarized. Make connections using
cable conforming to the Electrical
Equipment Handling Law and with a
nominal cross-sectional area of 0.128
mm
2 (wire number AWG26) or more.
The maximum cable length (distance
between priority switchbox and control
panel) is 10 meters.
The connection terminals differ depending
on the control panel model. The correct
connection terminals are listed below.
AW-RP301:
TALLY HOT and GND terminals.
AW-RP305:
Any of terminals TALLY 1 through
TALLY 5 and the GND terminal. (Make
sure that the pan/tilt head control
connector number to which the AW-
HB605 is connected and the TALLY
terminal number to which the priority
switchbox is connected match.)
Also, if the pan/tilt head is being
controlled via the AW-HB605, it is
necessary to select the number to which
the AW-HB605 is connected using the
pan/tilt head selector switch of the AW-
RP305.
AW-RP501:
TALLY HOT and GND terminals.
AW-RP505:
TALLY 5 and GND terminals.
$ Priority Switchbox
<