Panasonic AJ-HPX3700 - Manual (Page 20)

179 Menu: Menu Description Tables
Me
nu
The ____ in the Adjustable Range column indicates the preset mode.
ZEBRA Pattern Display
VF
VF DISPLAY
Items/
Data Saved
Adjustable
Range
Remarks
STATUS MODE NORMAL
FILM REC
For selecting the status display mode of
the viewfinder.
NORMAL:
Normal status display
FILM REC:
Status display for FILM REC
Note
Setting STATUS MODE to “FILM REC”
disables the DISP CONDITION and
DISP MODE settings.
– C U F R
DISP
CONDITION NORMAL
HOLD NORMAL:
Display status constantly.
HOLD: Display status only when the
MODE CHECK switch is
pressed.
– C U F R
DISP MODE 1
2
3 Set the DISP MODE.
Switch the camera’s Warning/Message
indication. Please refer to [Display
Modes and Setting Changes/adjustment
Result Messages] (page 84) for more
information.
– C U F R
VF OUT Y
NAM
R
G
B For selecting the video signals to display
in the viewfinder screen.
Y:
Brightness signal
NAM: Output signal with the highest
level among R, G, and B signals.
R: Rch signal
G: Gch signal
B: Bch signal
– C U F R
VF DTL 00
:
05
:
10
For setting the detail level of the
viewfinder screen.
The details of the signals for the
viewfinder are further enhanced. If “0” is
selected, then the detail is the same as
that for the main line.
– C U F R
VF DTL CORING 00
:
15
For setting the noise elimination level for
detail in the viewfinder signal.
– C U F R
VF H.DTL FREQ. 1
:
4
:
6
For selecting the horizontal detail
frequency in the viewfinder signal.
S C U F R
ZEBRA1
DETECT 0%
:
70%
:
109%
Set the ZEBRA1 detection level (IRE
value).
– C U F R
Items/
Data Saved
Adjustable
Range
Remarks
ZEBRA2
DETECT 0%
:
85%
:
109%
Set the ZEBRA2 detection level (IRE
value).
– C U F R
ZEBRA2 OFF
SPOT
ON Set the ZEBRA2 to “ON”, “OFF”, or
“SPOT”.
– C U F R
LOW LIGHT LVL OFF
10%
15%
20%
25%
30%
35%
Set the camera incoming light volume at
which to display “LOW LIGHT”.
– C U F R
RC MENU DISP. ON
OFF
For the setting to display the menu in the
viewfinder screen when the remote
control unit is connected to the unit.
– C U F R
MARKER/CHAR
LVL 50%
60%
70%
80%
90%
100% Adjust the brightness of markers and
characters displayed on the viewfinder.
– C U F R
SYNCHRO
SCAN DISP. sec
deg Set the units for the SYNCHRO SCAN
mode display.
sec:
Display using time.
deg: Display using opening angle of
the shutter.
– C U F R
SPOT OFF ON
109%
0%
ZEBRA 2
DETECT
ZEBRA 2
ZEBRA 1
DETECT
Video Level
AJ-HPX2700G-VQT1V27_eng.book 179 ページ ２００８年９月２日 火曜日 午後５時４３分