Pioneer SX-LX03 - Manual (Page 21)

Speaker Setup Guide (LX03BD) 02
21
En
English
Français
Deutsch
Nederlands
Italiano
Español
• You may purchase and use your own
speaker cables if desired. For details, see
Using your own speaker cables on page 22.
• The front and surround speaker cables
have a color-coded connector at one end
and two bare wires at the other end.
• Two purple cables are provided for the
subwoofer, one 4 meters and the other 10
meters in length. Use the appropriate cord
depending on the length needed for the
installation location.
• Since there is only one terminal to connect
the two center speakers, you will need to
use the supplied Y-cable for the connection.
• Twist and pull off the protective shields on
each wire.
• Connect the wires to the speaker. Each
speaker in the illustration can be identified
by means of the color-coded indicator
provided on the rear-surface label.
Match the color-coded wire with the color
indicator on the label, then insert the color-
coded wire into the red (+) side and the
other wire into the black (–) side.
• When connecting the center speakers,
connect the Y-cable dual end to the two
center speakers in the same way.
• Connect the other end to the color-coded
speaker terminals on the rear of the
receiver. Make sure to insert completely.
The small lug at the wire-end of the speaker
plug should face up or down depending on
whether it’s being plugged into one of the
upper or lower speaker terminals. Please
make sure to connect correctly.
• Fasten the cables together with the spiral
wrap.
Hold multiple cables together and place
the wrap over the cables from the end.
Wrap the spiral wrap with the cables in the
center.
The spiral wrap may be cut at a desired
length.
Color-coded wire
(Connect to speaker)
Color-coded connector
(Connect to rear panel)
Black (–)
Color-coded wire
Red (+)
Y-cable
To receiver
Upper terminal Lower terminal
LX03BD_1.book Page 21 Monday, July 28, 2008 2:12 PM