Panasonic SC-AK960 - Manual (Page 16)

16
RQT8043
RQTX0169
L
A
N
G
-
5
LANG - 5
L
A
N
G
-
4
LANG - 4
F
R
A
N
Ç
A
IS
FRANÇAIS
D
A
N
S
K
DA
N
S
K
E
N
G
L
IS
H
ENGLISH
External unit (continued)
Recording from a USB mass Recording from a USB mass
storage class device
storage class device
1
Press [ 4, / REW ] or [¢, / FF] to select the desired track
for recording.
2
Press [ ¶, REC] on the main unit to start recording.
Compatible devices
Devices which are defi ned as USB mass storage class:
• USB devices that support bulk only transfer.
• USB devices that support USB 2.0 full speed.
Supported format
Files must have the extension “.mp3” or “.MP3”.
Note:
• CBI (Control/Bulk/Interrupt) is not supported.
• A device using NTFS fi le system is not supported [Only FAT
12/16/32 (File Allocation Table 12/16/32) fi le system is supported].
• Depending on the sector size, some fi les may not work.
• This unit can access up to 255 albums (including blank folders) and
2500 tracks.
• The maximum number of tracks in a folder are 999 tracks.
• Only one memory card will be selected when connecting a multiport
USB card reader. Typically the fi rst memory card inserted.
• Disconnect the USB card reader from the unit when you remove the
memory card. Failure to do so may cause malfunction to the device.
• Compatible audio device will be charged when in USB mode.
Avoid interfering with other Panasonic Avoid interfering with other Panasonic
equipment
equipment
Other Panasonic audio or video equipment may start functioning
when you operate the unit using the supplied remote control.
You can operate this unit in another mode by setting the remote
control operating mode to “REMOTE 2”.
The main unit and remote control must be set to the same mode.
1
Press and hold [EXT-IN] on the main unit. Then press [2]
on the remote control until “REMOTE 2” is displayed.
2
Press and hold [ENTER] on the remote control followed by
numeric button [2].
To change the mode back to “REMOTE 1”, repeat the steps above by
replacing [2] with [1].
Connecting and playing a USB mass storage Connecting and playing a USB mass storage
class device
class device
The USB connectivity enables you to connect and play MP3 tracks
from USB mass storage class. Typically, USB memory devices. (Bulk
only transfer)
Preparation
Before connecting any USB mass storage device to the unit, ensure
that the data stored therein has been backed up.
USB enabled device
(not included)
It is not recommended
to use a USB extension
cable. The device
connected via the cable
will not be recognised by
this unit.
1
Reduce the volume and connect the USB mass storage
device.
2
Press [ 6, USB] to start play.
To Action
pause play Press [ 6, USB].
Press again to resume play.
stop play Press [ 7, CLEAR].
“RESUME” is displayed. The position is memorized.
Press [
6, USB] to resume.
Press [ 7, CLEAR] again to clear the position.
skip tracks Press [ 4, / REW] or [¢, / FF].
skip album Press [ALBUM ( or )] in the play mode.
Press [ALBUM ( or )] once and then
the numeric buttons in the stop mode.
For other operating functions, they are similar as those described in
“Discs” (
\ page 8 ~ 10).
RQTX0169-P.indd 16 RQTX0169-P.indd 16 7/18/08 9:25:08 AM 7/18/08 9:25:08 AM