Using the sr+ mode with a pioneer plasma display, Other connections 11 – Pioneer S-DV440 User Manual
Using the SR+ mode with a Pioneer
When connected using an SR+ cable, a
number of features (such as automatic video
input switching and volume muting on the
plasma display) become available to make
using this unit with your Pioneer plasma
display even easier.
SR+ control options for Pioneer
on page 44 for information on
setting up the unit.
Make sure that the plasma display and
this unit are switched on and that they are
connected with an SR+ cable.
Using this unit with a Pioneer plasma
above for more on connecting these
To switch SR+ mode on/off, press SR+
(SHIFT + 7).
The front panel display shows the new setting;
shows in the display, it means
there is a communication problem
between the unit and the plasma display.
Check all connections and retry.
• The 3-ringed SR+ cable from Pioneer is
commercially available under the part
number ADE7095. Contact the Pioneer
Customer Support division for more
information on obtaining an SR+ cable.
• You won’t be able to use the remote sensor
of this unit with the
this unit connected to the
jack of your plasma display. You can use
the remote sensor of the plasma display
(even in standby) as long as the power isn’t
• The automatic volume muting feature is
enabled separately; see
options for Pioneer plasma displays
page 44. (You can also use the System
Setup menu to switch the SR+ mode of
• If you disconnect the SR+ cable or switch
the plasma display off while SR+ is on, the
setting automatically reverts to
This displays an error if you switch the
input of the unit with the plasma display
switched off. Likewise, if this unit is
switched off, the link with the plasma
display will be terminated.
XV-DV323.book 56 ページ ２００４年２月１０日 火曜日 午後６時１０分