Psion Teklogix Hand-Held Computer 7530 G2 - Manual (Page 178)

Chapter 5: Configuration
Non-Decoded Scanners
150 Psion Teklogix 7530 G2 Hand-Held Computer User Manual
5.11.2.4 EAN 13
Enabled
Set this parameter to on to enable “EAN 13” or off to disable it.
Enable Bookland EAN
Setting this parameter to ON allows your scanner to recognize Bookland EAN
bar codes.
Include Country
If this parameter is enabled, the country code is included with the decoded bar
code data.
Include Check
If this parameter is enabled, the check digit is included with the decoded bar
code data.
Addendum
Important: Before “Addendum” can take effect, the “Short Code” parameter
(see page 146) must be enabled.
An addendum is a separate bar code, supplementary to the main bar code.
This parameter provides three options:
Disabled, Optional
and
Required
.
Depending on the value chosen for this parameter, an addendum is recognized
or ignored.
• Double-tap on Addendum to display a dialog box listing your options.
• Highlight an item, and tap on OK.
When “Addendum” is set to Disabled
,
the scanner does not recognize an
addendum. If this parameter is set to Optional
,
the scanner searches for
an addendum and if one exists, appends it to the main bar code. When the
parameter is set to
Required
,
the scanner does not accept the main bar code
without an addendum.
Note: Setting ‘Addendum’ to Optional reduces performance. Optional
should only be selected if at least some of the bar codes being read
have addendums.