Primera Technology LX400 - Manual (Page 34)

30 Printing Using a PC
Output Mode
Do not present (use with Rewinder). The label stock does not
move after the last label is printed. This means that part of the
last label printed is still in the printer. This should be used
only if you have a label rewinder attached.
Present (Default). This setting will cause the printer to feed the
last label printed forward so that it and the previously printed
labels can be torn off using the tear bar. This will occur only if
there are no other print jobs in queue.
Cut (using optional cutter). Use this setting only if you have
the label cutter attachment (Primera Part # 074263)
Enable Bi-di Printing
This setting defaults to Yes for fastest printing. When enabled
you will be required to perform an alignment print after a new
cartridge is installed.
Offsets
If your label is printing horizontally or vertically offset
(printing on the liner or with white space left on the label) use
these offset setting to adjust the position of the print on the
label. Click Offsets... to reveal the properties button. Click
Properties. The following screen will appear. Refer to the
diagram to determine which direction to move the image,
tear off position or cut position.
510984.qxd 11/21/2006 9:08 AM Page 30
TOC INDEX