Panasonic EY3552 - Manual (Page 10)

- 10 -
Inserting Battery Pack
CAUTION:
Before inserting battery pack, check that the
power switch in the Metal Cutter actuates properly
and returns to the “OFF” position when released.
1.To insert the battery pack: (See Fig.2)
Slide the battery pack in place at the rear of the
metal cutter. The battery should snap into place.
If the battery is loose, it has not been properly
connected.
Fig.2
2.To remove the battery pack:
Press the two tabs on the sides of the battery
pack. Slide the battery pack out of the metal
cutter body.
IV . OPERATION
Before Using Metal Cutter
This tool is intended for cutting unhardened fer-
rous metal and nonferrous metal. Refer to the
“Accessories” section for a list of blades to be
used for the proper applications of this tool. The
following precautions must be followed to reduce
the risk of injury;
•Do not cut stacked materials. Cut one piece at a
time.
•Do not cut hardened steel.
•Cut materials with the wider edge of the shoe
over the clamped side of the material.
•Do not touch the saw blade, workpiece, or cutting
chips with bare hands immediately after cutting;
they may be hot and could burn skin.
Each time you use the metal cutter, you must
make sure it is in good operating condition.
Use the following checklist:
1.Is the blade installed in the correct direction?
The arrow on the blade must point in the same
direction as the arrow on the upper blade cover.
2.Is the blade installed properly?
Make sure the hex bolt is tightened securely.
(See Fig.12)
3.Does the blade look alright?
Replace the blade immediately if there are any
cracks in it or if any teeth are broken.
4.Does the lower guard close properly?
WARNING
To avoid injury, do not use the metal cutter if
the lower guard does not close quickly over
the blade.
5.Is the transparent guard securely installed?
6.Is the battery pack charged and inserted firmly to
the metal cutter?
7.Is the depth adjustment lever for cutting securely
tightened?
8.Is the workpiece securely clamped on a saw
horse or bench?
Using Metal Cutter
CAUTION:
To reduce the risk of injury read the Safety
Instructions at the front of this manual before using
the metal cutter.
WARNING
To reduce the risk of injury, wear safety goggles
or glasses with side shields.
Follow these steps:
Hold the metal cutter with both hands. (See Fig.4)
Do not attempt to remove cut material when blade
is moving.
1.Line up the sight line on shoe with your cutting
line. (See Fig.3)
Fig.3
Alignment with cutting line
•Use the notch as guide to establish cutting
position. Align the notch with cutting line.
As the cutting position may differ depending on
the blade, do a trial cut beforehand.
Notch
Cutting line
Guide line of blade front