Help messages, Specifications/help messages, English – Panasonic SA-XR58 User Manual

Page 38

Advertising
background image

ENGLISH

RQTV0156

38

Specifications (DIN 45 500)

AMPLIFIER SECTION

Power output (at AC 230 to 240 V)

DIN 1 kHz (T.H.D. 1 %)

2 x 100 W (6

Ω)

20 Hz to 20 kHz continuous power output

both channel driven

2 x 80 W (6

Ω)

Total harmonic distortion

rated power at 20 Hz to 20 kHz

0.09 % (6

Ω)

Power bandwidth

both channel driven, -3 dB

4 Hz to 88 kHz (6

Ω, 0.9 %)

Power output each channel driven (at AC 230 to 240 V)

DIN 1 kHz (T.H.D. 1 %)

Front (L/R)

100 W (6

Ω)

Center

100 W (6

Ω)

Surround (L/R)

100 W (6

Ω)

Surround Back (L/R)

100 W (6

Ω)

Load impedance

Front (L/R)

A or B

6

Ω to 16 Ω

A and B

6

Ω to 16 Ω

BI-WIRE

6

Ω to 16 Ω

Center

6

Ω to 16 Ω

Surround (L/R)

6

Ω to 16 Ω

Surround Back (L/R)

6

Ω to 16 Ω

Frequency response

CD, DVD, DVD Recorder, VCR, TV/STB, AUX

4 Hz to 88 kHz, ±3 dB

DVD 6CH

4 Hz to 44 kHz, ±3 dB

Input sensitivity and impedance

CD, DVD/DVD 6CH, DVD Recorder, VCR, TV/STB, AUX

200 mV/22 k

S/N at rated power (6

)

CD, TV/STB, DVD, DVD Recorder (Digital input)

90 dB (IHF, A: 103 dB)

Tone controls

BASS

50 Hz, +10 dB to -10 dB

TREBLE

20 kHz, +10 dB to -10 dB

Channel balance (250 Hz to 6.3 kHz)

±1 dB

Channel separation

55 dB

Subwoofer frequency response (-6 dB)

7 Hz to 200 Hz

FM TUNER SECTION

Frequency range

87.50 MHz to 108.00 MHz

Sensitivity

S/N 30 dB

1.5 µV/75

S/N 26 dB

1.3 µV/75

S/N 20 dB

1.2 µV/75

IHF usable sensitivity (IHF ’58)

1.5 µV/75

IHF 46 dB stereo quieting sensitivity

22 µV/75

Total harmonic distortion

MONO

0.2 %

STEREO

0.3 %

S/N

MONO

60 dB

STEREO

58 dB

Frequency response

20 Hz to 15 kHz, +1 dB, -2 dB

Alternate channel selectivity

±400 kHz, 65 dB

Capture ratio

1.5 dB

Image rejection at 98 MHz

40 dB

IF rejection at 98 MHz

70 dB

Spurious response rejection at 98 MHz

70 dB

AM suppression

50 dB

Stereo separation

40 dB

Carrier leak

19 kHz, -30 dB

38 kHz, -50 dB

Channel balance (250 Hz to 6.3 kHz)

±1.5 dB

Limiting point

1.2 µV

Bandwidth

IF amplifier

180 kHz

FM demodulator

1000 kHz

Antenna terminal

75

Ω (unbalanced)

AM TUNER SECTION

Frequency range

522 kHz to 1611 kHz (9 kHz steps)

530 kHz to 1620 kHz (10 kHz steps)

Sensitivity

20 µV, 330 µV/m

Selectivity (at 999 kHz)

55 dB

IF rejection (at 999 kHz)

50 dB

VIDEO SECTION

Output voltage at 1 V input (unbalanced)

1± 0.1 Vp-p

Maximum input voltage

1.5 Vp-p

Input/output impedance

75

Ω (unbalanced)

S-Video

Input

DVD, DVD Recorder, TV/STB

Output

TV MONITOR

Component Video

Input

DVD Recorder, TV/STB

Output

TV MONITOR

GENERAL

Power supply

AC 230 to 240 V, 50 Hz

Power consumption

140 W

Dimensions (W x H x D)

430 mm x 107.5 mm x 390 mm

Mass

4.7 k

g

Notes:

Specifications are subject to change without notice.

Mass and dimensions are approximate.

Total harmonic distortion is measured by the digital spectrum

analyzer.

1.

2.

3.

Digital input

(OPTICAL)

2

(COAXIAL)

2

HDMI (Version 1.2a) Input

1

Output

1

Power consumption in standby mode:

0.9 W

Power consumption in HDMI off mode:

0.35 W

Help messages

Message

Causes and solutions

Muting is on.

Press [MUTING] on the remote control to cancel (

page 31).

You are trying to use a feature that is available only in

“MUSIC” mode.

Change the mode to

“MUSIC” (

pages 22 to 23).

Center and surround speakers are not connected, or they are set as absent.

Connect the speakers (

page 13) or change their setting to present (

page 27).

Surround and surround back speakers are not connected, or they are set as

absent. Connect the speakers (

page 13) or change their setting to present

(

page 27).

Surround back speakers are not connected, or they are set as absent. Connect

the speakers (

page 13) or change their setting to present (

page 27).

You are trying to use an effect unavailable with DTS-ES sources.
You are trying to use an effect unavailable with DVD-Audio sources.
You are trying to use an effect unavailable with DVD analogue 6-channel input.
You are trying to use an effect unavailable with the current input source.

(flashing)

You have set the

“PCM FIX” mode. Cancel this mode (

page 28).

SPEAKERS A is off. Press [SPEAKERS A] to turn on

“SPEAKERS A” (

page

18).
SPEAKERS A and SPEAKERS B are off. Select one of the speakers (

page

18).

Specifications/Help messages

SA-XR58.indb 38

6/27/2006 6:55:48 PM

Advertising