Philips VR102 - Manual (Page 13)

- 13 - EN
Copying a Video Tape
Make sure ...
• You must use the remote control for this procedure.
You can make copies of video tapes made by friends or relatives for your enjoyment.
WARNING: Unauthorized recordings of copyrighted video tapes may be an infringement of
copyright laws.
Connect the recording VCR (this unit), playing VCR (another VCR) and your TV using the following
diagram.
1. Insert a pre-recorded video cassette into the
playing VCR.
2. Insert a blank video cassette, or one you want
to record over, into the recording VCR cas-
sette compartment.
3. Press [SPEED] to select the desired record-
ing speed (SP/LP).
4. Select the input mode on the recording VCR.
See “External Input Mode”.
5. Press [REC/OTR] on the recording VCR.
6. Begin playback of the tape in the playing
VCR.
NOTES:
• For best results during dubbing, use the
VCR’s front panel controls whenever possible.
The remote control might affect the playback
VCR’s operation.
• You can use the A/V outputs of a video disc
player, satellite receiver, or other audio/video
component in place of the playing VCR.
• If video or colour fades in and out, you may
be copying a copy guarded video tape.
Turn on the TV and select the TV channel to the
video channel.
To Monitor The Recording
RF OUT
TV
AERIAL Aerial jack
[TV set]
(Use for monitoring)
[Editing (Recording) VCR]
(this unit)
[Source (Playing) VCR]
(another VCR)
Euro audio/video
(not supplied)
Coaxial cable
(supplied)
H87T4(EN)BACK.QX33 01.7.3 6:44 PM Page 13