Panasonic EY7410 - Manual (Page 6)

- 6 -
Reference for Adjusting Torque
Scale Torque Use
1
Approx: 0.9 N·m
(.0 kgf-cm or .6 in-lbs)
For driving
screws
5
Approx: 0.8 N·m
(8. kgf-cm or 7. in-lbs)
9
Approx: 1.5 N·m
(1.8 kgf-cm or 1.0 in-lbs)
1
Approx: 1.88 N·m
(19. kgf-cm or 16.6 in-lbs)
17
Approx: .1 N·m
(.6 kgf-cm or 1. in-lbs)
1
Approx: .9 N·m
(0.0 kgf-cm or 6.0 in-lbs)
Approx: . N·m
(5.0 kgf-cm or 9.0 in-lbs)
For power-
ful driving
screws and
drilling
● When using at high speeds, set the
scale at 10 or below. (Operation
stops at the maximum torque of 1.5
N·m (15 kgf-cm) when the scale is
higher.)
● The auto shut-off function may be-
come inoperable at use at higher
scales when battery power drops.
Recharge the battery in that case.
NOTE:
The chart is only a reference. The
torque setting may differ by materi-
als, types of screws, etc. Please test
it at your own conditions before use.
 Battery Low Warning Lamp
<Battery low warning lamp>
Off
(normal
operation)
Flashing
(No charge)
Battery
protection
feature active
Excessive (complete) discharging of
Li-ion batteries shortens their service
life dramatically. The driver includes a
battery protection feature designed to
prevent excessive discharging of the
battery pack.
● The battery protection feature acti-
vates immediately before the bat-
tery loses its charge, causing the
battery low warning lamp to flash.
● If you notice the battery low warn-
ing lamp flashing, charge the bat-
tery pack immediately.
 Clutch Lock Cover
The clutch lock cover allows you to
lock the clutch at the selected gradu-
ation.
Attaching the cover
1. Select the torque required to move
the clutch.
. Attach the clutch lock cover.
● Align the triangle mark on the
cover with the graduation selec-
tion mark on the drill and attach.
Triangle mark Graduation selection
mark
Removing the cover
1. Grip the clutch lock cover with your
fingers on the  mark and the bot-
tom of the cover and remove.
● It will be difficult to remove the
clutch lock cover from the drill if
you push on the side of the cover
while pulling it off.
 Using the LED Light
Use the LED light on jobs in dark
locations such as attics to illuminate
your workspace.
CAUTION
● The LED light is intended for use as
a supplemental light source. Do not
use it as a flashlight.
Doing so may result in accident or
injury.
EY7410(EU).indb 6 2006/07/19 17:27:45