Precor Electronic Console with the Pulse Feature 903 - Manual (Page 12)

page 12
Installing the Mounting Pads
Two adhesive-backed foam pads (one thick and one thin pad)
accompany your electronics option package. The thick pad is
used as a spacer and you place the reed switch on it. The thin
pad is positioned onto the flywheel and becomes the base for
the magnet.
CAUTION: Both pads require a 24-hour period to bond
properly to the equipment. Do not operate the treadmill
during this time.
Diagram 9
Place mounting
pad here
To install the mounting pads to the flywheel and side rail on your
903 or 904 treadmill, take the following steps:
1. Locate the area on the side rail between the right roller
guard and the deck of the treadmill. See Diagram 9.
Note: Right and left are determined by standing behind the
rear roller and facing the handrail(s).