Connecting the dp-c106 to the network, Connecting the dp-c106 to the network -12 – Panasonic DP-C106 User Manual
Page 127
Connecting to the Network
4–12
Connecting the DP-C106 to the Network
Complete the following steps before you configure the DP-C106 and
the workstations that will print to it:
1.
Ensure that the DP-C106 is plugged in, switched On, and
functioning properly.
2.
Prepare the network servers to share DP-C106 software and to
enable networked users to print to the printer.
3.
Power Off the DP-C106.
CAUTION
Do not attach cables to more than one Ethernet connector; only one
Ethernet connection can be made at any one time.
4.
Connect the appropriate network cable to the printer:
•
For
UTP cable for 100Base-TX or 10Base-T, connect the
RJ-45 cable connector to the RJ-45 socket on the back of
the printer.
•
For
parallel cabling, connect the Centronics cable to the
parallel port on the back of the printer. Connect the other
end of the cable to the parallel port on the Windows
workstation. Power On the workstation and the DP-C106.
5.
Configure network servers for printing. Refer to