Pioneer Multi Projection System RM-V1000NU - Manual (Page 31)

30
INSTALLATION AND ASSEMBLY
(2) Inserting the Option Board (MVP)
[1] Remove the rear cover C (R) and rear cover C (L). (Six screws for each)
[2] Remove the UL cover A. (Six screws)
[3] Remove the UL cover C. (Two screws)
[4] Disconnect the MVP power cord.
[5] Disconnect the connector and remove the power supply. (Three screws)
[6] Remove the four screws in front of the MVP.
[7] Tilt the MVP slightly, and pull it out.
[1]
Rear cover C (L)
Rear cover C (R)
[2] [3] [6] [7]
UL cover A
UL cover C
[4] [5]
Pull in this direction