Pioneer Multi Projection System RM-V1000NU - Manual (Page 79)

78
ADJESTMENTS
[4] <GWB> (GET W/B DATA)-White balance adjustment data is output.
Format : Output in the following order.
1STX (02H)
2<LWT>/ LINEAR WHITE
adjustment data (3 BYTE)
3<CNT>/CONTRAST adjustment data (3 BYTE)
4<BRT>/BRIGHTNESS adjustment data (3 BYTE)
5<COL>/COLOR adjustment data (3 BYTE) (Note 1)
6<TNT>/TINT adjustment data (3 BYTE) (Note 1) and (Note 3)
7<BLW>/BLUE LOW-LIGHT adjustment data (3 BYTE)
8<GLW>/GREEN LOW-LIGHT adjustment data (3 BYTE)
9<RLW>/RED LOW-LIGHT adjustment data (3 BYTE)
0<BHI>/BLUE HIGH-LIGHT adjustment data (3 BYTE)
-<GHI>/GREEN HIGH-LIGHT adjustment data (3 BYTE)
=<RHI>/RED HIGH-LIGHT adjustment data (3 BYTE)
~<SHP>/SHARPNESS adjustment data (3 BYTE) (Note 1) and (Note 5)
!<ABL>/ABL LEVEL adjustment data (3 BYTE) (Note 4)
@<ABG>/ABL GAIN adjustment data (3 BYTE) (Note 2)
#ETX (03H)
(Note 1) Dummy when INPUT=RGB
(Note 2) No dependent on mode. (Has one data.)
(Note 3) Dummy when PAL signal is input. (INPUT=VIDEO or Y/C)
(Note 4) Dummy when COMBINATION=OFF (Data is output when COMBINATION=ON)
(Note 5) SHARPNESS data for OFF is output when MULTI=OFF, and SHARPNESS data for ON is output when
MULTI=ON.
[5] <GUS> (GET CONV. USER DATA)=Deflection and convergence data memory area setting state is output.
1STX (02H)
2Memory area selected when INPUT=VIDEO or Y/C & input signal=NTSC.
(3 BYTE)
Example)US 1:Indicates CONV.MEMO-1 is selected.
3Memory area selected when INPUT=VIDEO or Y/C & input signal=PAL
(Or other than NTSC, containing no signals). (3 BYTE)
Example)US 2:Indicates CONV.MEMO-2 is selected.
4Memory area selected when INPUT=RGB & input signal=NTSC. (3 BYTE)
Example)US 1:Indicates CONV.MEMO-1 is selected.
5Memory area selected when INPUT=RGB & input signal=PAL (or other than NTSC, containing no
signals). (3 BYTE)
Example)US 2:Indicates CONV.MEMO-2 is selected.
6ETX (03H)