Polycom SOUNDPOINT 300/301 - Manual (Page 3)

2
Installing SoundPoint ® IP 300/301 SIP
This section provides basic installation
instructions and information for obtaining
the best performance with the Sound-
Point
® IP 300/301 SIP phone. If you re-
quire additional information or assistance
with your new phone, please contact your
system administrator.
The SoundPoint ® IP 300/301 SIP User
Guide includes regulatory compliance
information that your system administrator
should review and can also be found at:
www.polycom.com
Connecting Network and Power Source
AC Power Option
In-Line Power Option
Cisco™Catalyst™ In-Line
Power Switch
IEEE 802.3af compliant
In-Line Power switch
Connect the supplied Network
Cable between the LAN jack on
the phone and the LAN port on
the wall or hub/switch device port.
Connect the DC plug of the AC
wall adapter into the supplied LAN
cable as shown.
If the phone is connected to a compatible
Ethernet switch that can provide in-line
power, the phone will use that power option.
Simply plug the supplied Network cable
between the LAN jack on the phone and an
available Power and Data port on the In-Line
Power switch.
Cisco™ In-Line Power
Cable
(Part No. 2200-11014-002 Rev A)
OR
IEEE 802.3af In-Line
Power Cable
(Part No. 2200-11077-002 Rev A)