Printronix H-SERIES P7000 - Manual (Page 205)

205
Ribbon End Point, 99
Tear Bar Dist. (Distance), 100
Unidirectional, 100
View Function, 100
PRINTER HOT * message, 159
Printer interfaces, 111
Printer MGMT menu, 110
Mgmt Port Number, 110
Mgmt Protocol, 110
PNE Port, 110
PNE Port Number, 110
PNE Port Timeout, 110
Status Port Numb, 110
Printer Protocol
Hangul LP+ Emulation, 94
Hanzi LP+ Emulation, 94
Printer Tests, DIAGNOSTICS, 108
PRINTER UNDER REMOTE CONTROL
message, 159
Printing rates, 170
Printing, Hex Dump, 128
Protect Configs., 58
PROTECTED INSTR * message, 159
Protocols, 12
PRT CONFIG key, 21
PTX Setup Option, ADVANCED USER menu, 102
Pwr Save Control, ADVANCED USER, 105
PWRSUPP VOLT * message, 159
Q
QUEUE OVERRUN* message, 159
QUICK SETUP menu, 52
Adapter Address, 53
DBCS ASCII Style, 55
DBCS CPI, 54
DBCS/ASCII Mode, 55
Ethernet Address, 53
Graphics Speed-Up, 54
Host Interface, 52
Load Config., 55
Power-Up Config., 56
Reset Cmd CFG Ld, 55
Ribbon End Point, 55
Save Config., 56
SELECT LPI, 55
Typeface, 54
WLAN Address, 53
ZTP Data Time, 53
ZTP TearDistance, 54
ZTP Wait Time, 54
R
RBN AT END POINT message, 160
RBN Low Action, ADVANCED USER, 107
RBN Low Warn @, ADVANCED USER, 106
Ready, Dataproducts Parallel Interface
Signals, 122
Receive Data (RD), RS-232, 120
Reload paper, 23
REMOVE USED SPX message, 159
Renew Lifetime, WLAN Kerberos menu, 89
Report Status, Auto Switching submenu, 61
Request to Send
RS-232, 120
Serial submenu, 71
Requirements
power, 13
printer site, 13
Reset Cfg Names, 59
Reset Cmd CFG Ld, 55
Hangul LP+ Emulation, 97
Hanzi LP+ Emulation, 97
Reset Kerb. Pwd, WLAN Kerberos menu, 88
Reset LEAP Password, WLAN LEAP menu, 90
Reset LEAP User, WLAN LEAP menu, 90
Reset SSID Name, WLAN PARAMS menu, 85
Reset WEP Keys, WLAN PARAMS menu, 87
Reset WPA P-Phs, WLAN PARAMS menu, 87
Resistor configurations, terminating, 117
Resistors
installation, 118
removal, 118
Resistors, terminating
location of, 118