Pioneer VSX-41 - Manual (Page 47)

09
47
En
Controlling the rest of your system
Selecting preset codes directly
ENTER
MPX/RETURN DTV INFO
DTV ON/OFF DTV MENU
D.ACCESS T.EDIT/GUIDE
CLASS
FL DIMMER
BAND
TOP MENU AUDIO SUB TITLE
REMOTE SETUP
RECEIVER CONTROL
STANDARD ADV.SURR. STEREO
ANGLE
1 ¡ 4 ¢
7 8 3 ¶
LEVEL
DVD VCR CD-R TV
RCV TUN TVC CD
TEST TONE
CH SELECT
INPUT ATT
INPUT SEL. MUTE MIDNIGHT/ LOUDNESS SIGNAL SEL
MULTI CONTROL
EFFECT DISPLAY DISC +10
1 2 3
4 5 6
7 8 9
0
1 Press and hold REMOTE SETUP for
three seconds.
The LCD display shows SETUP.
2 Press the MULTI CONTROL button for
the component you want to control.
3 Use
} and ] to select DIR SET then
press REMOTE SETUP.
The LCD on the remote displays the
component you want to control.
4 Use the number buttons to enter the 4
digit preset code (see pages 55–66)
The LCD display shows the code as you
enter it. If you make a mistake press the
}
button to go back one digit. The display
shows
OK once you have entered a valid
code. If it’s an invalid code or an error has
occurred,
ERROR shows in the display.
If you get an error message, check the
preset code list and try again. If you can’t
find or properly enter a preset code, you can
still teach the remote individual commands
from another remote control (page 49).
• If you assign a preset code for the TUNER
button, you won’t be able to control the built-
in tuner of this receiver using the remote.
Reset the remote to the built-in tuner by
entering the preset code
7008.
5 Repeat steps 1 through 4 for the other
components you want to control.
Setting the remote to control
other components
There are several ways to set your remote to
control the other components in your system.
The easiest way to do this is to assign the
component’s manufacturer preset code (listed
on page 55) to one of the
MULTI CONTROL
buttons on the remote control.
The buttons can be set to control the following
components:
Controllable Components
DVD or LD player
TV or Satellite tuner
VCR or Digital Video Recorder
CD player
CD Recorder, Tape deck
or MD player
TV or Cable TV tuner
FM/AM tuner
Button
DVD:
TV:
VCR:
CD:
CD-R:
TVC:
TUN:
You can do this directly, or by searching
through different preset codes until you find
the right one. If you can’t find a preset code
that matches the component you want to
control, you can still teach the remote
individual commands from another remote
control (page 49–50).
You can cancel or exit any of the steps by
pressing and holding
MUTE for three seconds.