Pioneer VSX-41 - Manual (Page 51)

09
51
En
Controlling the rest of your system
Direct function
• Default setting: ON
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the remote
control to set up and listen to a CD on the
receiver and then use the remote control to
rewind a tape in your VCR while you continue
to listen to your CD player.
When direct function is on, any component you
select (using the
MULTI CONTROL buttons )
will be selected by both the receiver and the
remote control. When you turn direct function
off, you can operate the remote control without
affecting the receiver.
1 Press REMOTE SETUP and hold for
three seconds.
The LCD display shows SETUP.
2 Press the MULTI CONTROL button for
the component you want to control.
3 Use
} and ] to select DIR SET then
press REMOTE SETUP.
The LCD on the remote displays the
component you want to control.
4 Use the number buttons to enter either
9990 (direct on) or 9995 (direct off).
The LCD will display OK to show the four
digit code has been accepted.
You can’t use direct function for TV INPUT.
Confirming preset codes
Use this feature to check which preset code is
assigned to a
MULTI CONTROL button.
1 Press REMOTE SETUP and hold for
three seconds.
The LCD display shows SETUP.
2 Press the MULTI CONTROL button of
the component for which you want to
check the preset code.
3 Use
} and ] to select READ ID and
then press REMOTE SETUP.
The preset code appears in the display for
two seconds.