Polycom SpectraLink 6100 MCU - Manual (Page 15)

3
Site Preparation
Required Materials Provided by Customer
The following equipment must be provided by the customer:
† Outlet Strip Recommended for installations with more than one
MCU. This will allow the MCUs to be turned on and off together.
† Cross-Connect Block Required to connect the telephone switch
ports and the Base Stations to the MCU.
† 25 Pair Cables RJ-21 male at MCU end, required to connect the
MCU to the cross-connect blocks.
† Backboard Space The MCU is designed to be wall mounted to
3/4” plywood securely screwed to the wall.
† Quick Clip Fuse Required with an RCO410 Outdoor Base Station
or when a Base Station is located in a separate building from the
SpectraLink 6100 MCU. Recommended Quick Clip Fuse is
available from Illinois Tool Works, Linx Division, Model # SCP-
2X2.
† Base Station Mounting Hardware If the Base Stations will be
mounted on finished walls or ceilings, a 4 to 5” long 1/4” bolt,
nuts, and washers will be required for each Base Station mounted.
PN: 1725-36097-001_G.doc 15