Polycom SpectraLink 6100 MCU - Manual (Page 57)

Safety Notices
WARNING: Changes or modifications to this equipment not
approved by Polycom may cause this equipment to not comply with
part 15 of the FCC rules and void the user’s authority to operate
this equipment.
WARNING:
Polycom products contain no user-serviceable parts
inside. Refer servicing to qualified service personnel.
IMPORTANT SAFETY INFORMATION
Follow these general precautions while installing telephone
equipment:
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
• Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected at the network
interface.
• Use caution when installing or modifying telephone lines
• When installing Base Stations outside or in buildings other than
the one containing the System Controller, take the following
precaution:
If wiring for a Base Station exits a building—whether to reach
an outdoor Base Station location or to reach a Base Station in
another building—the wiring must be protected at both ends by
a Quick Clip Fuse from Illinois Tool Works, Linx Division, model
number SCP-2X2. The Quick Clip Fuse replaces the bridging
clips on the 66 blocks for all four connections to the non-internal
Base Station.
PN: 1725-36097-001_G.doc 57