Dealing with problems (summary) – Panasonic CF-29 User Manual

Page 28

Advertising
background image

T

ro

u

b

leshooting

28

Dealing with Problems (Summary)

During simultaneous dis-
play, one of the screens be-
comes disordered

When an a moving picture
such as an MPEG file is be-
ing played with Media
Player, the display destina-
tion cannot be switched us-
ing

Fn

+

F3

Try changing the display by pressing

Fn

+

F3

.

If you continue to experience problems, try changing the display destination in the fol-
lowing menu.
[start] - [Control Panel] - [Other Control Panel Options] - [Intel(R) Extreme Graphics 2
M] - [Devices]
When the [Command Prompt] is set to “Full Screen” by pressing

Alt

+

Enter

, the

picture is displayed on one of the screens only. When the window display is restored by
pressing

Alt

+

Enter

, the picture is displayed on both screens.

The display destination cannot be switched while a moving picture such as an MPEG file
is playing. Stop playing the moving picture before switching the display destination.

Display (continued)

Windows cannot be shut
down or restarted

Shutting Down

If a USB device is connected, try removing it.

Battery Indicator

The red indicator lights.

The red indicator blinks

The orange indicator blinks

The green indicator blinks

The battery indicator blinks
green and orange alternately

The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the battery indicator light is
orange. If you do not have an AC adaptor, save your data and power off your computer.
After replacing the battery pack with a fully charged one, turn your computer on.

Quickly save your data and power off your computer. Remove the battery pack and dis-
connect the AC adaptor, then connect them again.
If the problem persists, contact Panasonic Technical Support. Possible failure in the
battery pack or charging circuit.

Battery cannot be recharged temporarily because the internal temperature of the battery
pack is outside of the acceptable temperature range for recharging. Once the allowable
range requirement is satisfied, charging begins automatically. Your computer can be
used normally in this state.

In high temperature mode, the battery is discharging to the level that corresponds to an
80%*

1

charge for normal temperature mode. (

“Battery Power”) Do not re-

move the battery pack while the battery indicator is blinking green.

*

1

In high temperature mode, the level that corresponds to an 80% charge for normal temperature

mode is displayed as [100%].

Warming up the system to prevent hard disk drive malfunctions at low temperature. Leave
your computer as is. Once the allowable temperature range requirement is satisfied, your
computer will start automatically.

Advertising