Panasonic AW-PH650N - Manual (Page 22)

22
Installation
<When a large lens is used>
A large lens can be attached to the AK-HC910 or
AK-HC1500, and stowed inside the housing for use. In a
case like this, attach it by following the steps below.
Use any of the large lenses listed below.
HA42 × 13.5 BERD or A42 × 13.5 BERD made by
Fujinon Corporation
HJ40 × 14B IASD-V or J35e × 15B IASD made by Canon
Inc.
No other lenses can be used.
 How to attach the lens
 Remove the lens hood and zoom lever of the large lens.
 Place the assembly of the camera mount, camera and
large lens inside the housing from the front edge of the
lens.
Hook a piece of string (supplied) around the lens barrel,
and stow the assembly inside the housing. At this point,
with the assembly tilted at an angle of around 45 degrees
() as shown in the figure below, position the entire
lens motor drive area at the front right inside the inner
wall of the housing and the lens holder in front of the I/F
connector, and insert it diagonally with the front end of
the lens first.
After stowing the lens unit, return the tilted camera to its
original angle (), place the camera mount up against
the support ribs on both sides of the housing, and fit
these areas between the plate nut and mount.
Lens hood
Zoom lever
 Fit the camera and lens together.
Mount the camera mount on the top panel of the camera.
For details on how to mount it, refer to the section on how
to mount the cameras and mount.
 Connect the supplied camera cable to the I/F REMOTE
connector at the back of the camera.
In order to make it easier to connect the cable after
stowing the lens unit, the cable must be connected
here when a large lens is to be used.
Lens holder
Lens motor
drive area
Camera mount
support ribs
I/F connector area
of the housing
Lens holder
( Insert this in
front of the I/F
connector.)
Camera mount screws
Camera mount Lens motor drive area


String
 Attach the lens holder (supplied) to the lens supporter
mounting screw on the bottom of the lens.
Lens holder
Allen key
Lens supporter
mounting screw
Washers
Mounting
screw
M6 mounting screws (supplied) are used for a Fujinon
lens; M5 mounting screws (supplied) are used for a
Canon lens.