Panasonic AW-PH650N - Manual (Page 6)

6
Mounting (Pan/tilt head)
Precautions for installation
 Do not install this unit by suspending it, and do not install
it on its side.
 Using the four pan/tilt head mounting holes, fasten the
unit securely with bolts which are long enough.
The mounting holes have a diameter of 3/8” (10 mm). Use
sufficiently long bolts with an 5/16” (8 mm) diameter. Do
not use bolts with a diameter smaller than 5/16” (8 mm).
Use hexagon head bolts or hexagon socket head bolts,
for instance, which can be tightened up securely using a
tool and which are made of a material and with a finish
that will withstand outdoor use.
 Be absolutely sure to use parts such as flat washers or
spring washers together with the bolts to prevent the bolts
from coming loose.
How to install
 Attach one end of the anti-fall wire to the mounting hole,
and secure the other end to the mounting base or other
sturdy place.
The diameter of the hole where the anti-fall wire is
attached is 6.5 mm. Attach the wire using the anti-fall wire
mounting bolts with a 6 mm diameter and a length of 16
mm, flat washers, spring washers and nuts.
Ensure that the anti-fall wire is strong enough to bear the
weight of the entire pan/tilt head (head, housing, camera
and cable).
The diameter of the four pan/tilt
head mounting holes are 3/8 (10).
<Dimensions of area where unit is mounted>
6-5/16 (160)
7-1/2 (190)
5-1/2 (140)
6-11/16 (170)
Mounting area
Mounting base
Mounting bolts
Anti-fall wire bolt Anti-fall wire
Unit: inch (mm)
9/16
(15)
9/16 (15)
9/16
(15)
9/16 (15)